Plastic Bender

From Fox.Build Wiki
Jump to: navigation, search
Plastic Bender

The plastic bender was made at Fox.Build for bending sheet plastic. It can bend plastic up to 24 inches in width. The procedure to operate the bender is:

  1. ) Place the plastic on the bender with the line to be bent centered above the groove in the bender
  2. ) Turn on the power supply and watch for the wire to turn red hot
  3. ) Wait until the plastic appears soft on the top, then lift the front of the bender up to the desired bend angle while keeping the plastic from moving
  4. ) Remove the plastic from the bender and hold it in position until it has cooled
  5. ) Turn off the power supply